PDA

View Full Version : High Roller Camaro coming together

High Roller
03-03-2009, 07:03 PM
Rear susp all back together with upgrades, new "pretty in pink" converter retuned for MAX spray, trans in, bars shortened, and new plumbing to try to work that converter even harder.

Yea thats right......its oooooown baby.

Carb stuff still en route.

Looks like I will probly be running PUMP E85. My tune up is way more forgiving, and with the tester we will know whats going in. Done some diggin since the meeting and we will see, but thats my plan unless the tester shows somn crazy. May have to wait a bit for closer to summer blend but ill let ya know what we have around here.
Purple66bu
03-04-2009, 07:24 PM
Lets see some pics Mike!!
High Roller
03-05-2009, 08:21 AM
WTH are you tring to get my speed secrets?!?!?!?! Ha ha...Yea Ill try to get somn, I am more concerned with gettign DONE. Testing time is going to run real short, real soon, and I need it!!!

Plus the underside of my ride isnt as nice as it should be since it has seen too many illinois roads (and still will!!!!).
Hurst390
03-07-2009, 02:04 PM
We drove by your place earlier..I didn't see any "Action" goin on?
High Roller
03-07-2009, 03:39 PM
We drove by your place earlier..I didn't see any "Action" goin on?

Late night motorsports bro.....gotta CATCH me in action......if you can


I assume you are converting Snot Rod o be "green"er than it already is......
High Roller
03-09-2009, 08:35 PM
Almost back on the ground tonight. About time to terrorize the neighborhood again!!!!! Then switch fuels and do it all over again!!!!
High Roller
03-19-2009, 08:05 AM
Got heat in the pipes and fog hangin in the venturis last night!!!! This is good and bad, I dont think the converter is where I had wanted it, but now a decsion of test it or not comes in. I may run out of time for a converter alteration if it doesnt work. :confused:
High Roller
03-20-2009, 09:17 PM
On the ground. Probly back her out tomorow. Still gotta do some wire tying things back into place and finish weld the upper wheelie bars. I think I am going to leave the fogger alone until all is right with e 85 conversion and the plate system is figured out on the corn juice. This way I dont have to buy as many jets initially. Heck may be Ill get lucky and get it to run it on the plate only, but that is one REAL slim chance!